[Shaft]

Hey Everyone.

I seen a few posts but lacking much detail.

So I'm hoping someone could shed some light here.

What adapters are used for the Bolt speaker doors for aftermarket speakers? I'm seeing Volt/Malibu adapters and other GM vehicles.

Has any used a 4 channel amp tapped into the hi level inputs for the speakers? Where would you find the Bolt's factory audio unit to tap into?


This is something i'm looking to tackle asap.

thanks!

 

[Shaft]

No one?
Wow!

I'll be diving into this territory next week when door plates arrive.

 

[XJ12]

Pretty sure you've looked these over already:

http://www.chevybolt.org/forum/26-electronics-audio-lighting/22113-sub-amp-install-done-noob.html

http://www.chevybolt.org/forum/116010-post31.html

http://www.chevybolt.org/forum/226-interior/10610-front-rear-door-panel-removal.html

 

[Shaft]

Yes I had a look at all 3 postings. None of them are complete in their write ups. All left hanging.
None showing anything on wiring. Not DIY friendly.

 

[XJ12]

Yes I had a look at all 3 postings. None of them are complete in their write ups. All left hanging.
None showing anything on wiring. Not DIY friendly.

I can't read French either: http://menu-principal-forums-aveq.1097349.n5.nabble.com/Speaker-dans-la-LT-PVI-td64023.html

 

[Shaft]

that one was a bit more informative as I translated it before. The door plates he's using is smaller than the factory. I ordered one that fits a malibu. The part numbers for the door speakers match the malibu from the local GM dealership. Had them check. Should arrive next week

 

[XJ12]

@gaulfinger apologized on his video not turning out.

http://www.chevybolt.org/forum/324649-post12.html

Maybe you can PM him or @fire_qc

 

[gaulfinger]

Yes, I'm happy to field questions... You can message me here or leave a comment on my web site: www.aulfinger.us/CurrentCars

Gary

 

[Shaft]

Sent you a PM.