Chevy Bolt EV Forum banner
  • Hey Guest, welcome to We encourage you to register to engage in conversations about your Bolt.

Metal skid plate for chevy bolt EV

4706 Views 56 Replies 17 Participants Last post by  sendler2112
I ordered this plate from a place called Kolchuga.
The one pictured is a special extra thick one that I special requested.

it actually fits and works very well. The installation is a bit tricky, but the fitment is basically perfect

i ended up trimming this part
Wood Automotive exterior Hood Bumper Gas

Here is the old beat up 200k mile one
Gesture Road surface Wood Asphalt Font

Here it is installed. Note that the floor jack is just resting there with no pressure as a fifth support point do not lift the vehicle there.
Wood Tints and shades Automotive exterior Metal Composite material

I installed the back first. This seemed to work well. Not shown are brackets for the front part that attach to steering rack bolts. These were hard to install. Also note that it is possible to put the front most support bar (not pictured) in backwards. The 6 bolt holes aren’t symmetric. It only goes in one way
White Light Automotive tire Line Wood
See less See more
  • Helpful
Reactions: 3
1 - 2 of 57 Posts
Anything to protect the front of that battery. One damaged hose could total the car (which is insane).
How much did it cost for yours? You obviously have significant need living on a dirt road.
if you look up at the fifth post he says $500ish for the regular one and he asked them for an even thicker one that was $600ish,
Where's the "I'm an idiot" emoji?
1 - 2 of 57 Posts