Chevy Bolt EV Forum banner
1 - 4 of 4 Posts

·
Registered
2020 Chevrolet Bolt EV Premier
Joined
·
1 Posts
Discussion Starter · #1 ·
Does anyone know the torque specification for the Bolt's rear bumper bar fasteners? I have installed the Torklift EcoHitch on my 2020 Bolt EV, following the Torklift instructions and a handy video on the other community (EcoHitch install - Bolt EV Forum, page 3). However, nowhere have I found the torque spec, just reference to "the manufacturer's specifications". Thanks!
 

·
Registered
Joined
·
1,899 Posts
Yup, 38 ft-lbs. You can see at the 9 min 55 second point in my installation video in this thread I say the torque spec.


Keith
 

·
Registered
Joined
·
5 Posts
Has anyone tried the Curt hitch receivers, (1 1/4" or 2") that are less expensive than the Eco-Hitch, and comprable to the Draw-Tight in cost? I'm wondering pros and cons of each, and whether to get one with a 2" connector (my brother says 2" is better). Do you like your Eco-Hitch? Do you like your Draw-Tight? Any downsides?
 
1 - 4 of 4 Posts
Top