[1nterceptor]

Just a simple hack to the S10 jack. This will allow you to use a socket & ratchet or box end wrench or ratcheting box end wrench. Instead of the clumsy handle that's built-in to the jack.

There are tabs holding the handle in place. I used an old file and worked on the tab for about 15 minutes.

Once the tab is filed down; just pull the handle off. You can now operate the jack with a 19mm wrench or 19mm socket or lug nut wrench. The same tool you'll need to remove a lug nut.

Tools needed for a tire rotation; following GM recommendation of crossing:

 

[Packard V8]

A compact 18-volt impact gun and a 19mm socket and it's easier yet.

https://www.milwaukeetool.com/-/med...&mh=520&hash=616E79334FB44BCCE0E9F7A6917BEFB0

jack vines

 

[NortonCommando]

Tools needed for a tire rotation; following GM recommendation of crossing:
View attachment 34710

What are the angled sheet metal pieces?

 

[1nterceptor]

What are the angled sheet metal pieces?

Factory wheel chocks. When I bought the scissor jack from a seller on Craigslist - I asked him to check
the compartment of the 2001 Blazer for all of the kit; lug nut wrench, wheel chocks. They take up too
much room; though. I bought these folding ones from Amazon; these are what I carry in my car: