Chevy Bolt EV Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
105 Posts
Discussion Starter #1
Does anybody know what this hook is called and/or where I can find one? This is the little round insert piece in the trunk area that you attach the luggage cover shade thingie to. I lost one of 'em. My searching is hampered by not knowing the right term. Thanks!

 

·
Registered
Joined
·
3,824 Posts
Check with the parts desk at your Chevy dealer. If there is a separate part number for it, they should know it. I'd call it a cargo area security shade anchor insert, located in the rear interior lower quarter trim panel.
 

·
Registered
Joined
·
183 Posts
Just make sure the 'nice' parts guy doesn't try to convince you that it is only available with a set of parts that cost 100 dollars.

THIS is probably what you want.


I was bored and felt like flexing my Google skills. In the defense of ANYONE looking for it, it... was not easy to find the right combination of keywords and I just sat here looking at google images while my kid watched mind numbing children's programming.

Eventually found this reddit thread:

https://www.reddit.com/r/BoltEV/comments/azqbo2
It warns that the much much cheaper and common GM part that seems to fit everything other than the Bolt does NOT fit the Bolt. Do NOT get 25913048 or anything similar.
 

·
Registered
Joined
·
624 Posts
that thing is a terrible design, and one of mine falls out all the time. i'm sure i'll lose it, but $18 for one is highway robbery. i think i'll just get a dowel and stick through the loop in the cargo cover, and stick it in the hole. the tension of the cover should hold it in. if not, just affix it to the loop somehow.
 

·
Registered
Joined
·
3,795 Posts
Mine came off when one of the bayonet tabs that holds it in place broke. For a while I just screwed a cup hook into the recessed hole where the original part was, but I eventually replaced it with an OEM part from the GM parts department. I took a photo of it with me and we found it on the diagram in their parts database. The part description is "Cover" and it's part number 42482233. It cost me Cdn$28.50, plus taxes.
 

·
Registered
Joined
·
5 Posts
Question out of nowhere, is there an easy way to pop it out without destroying it?
I tried (only once) to put a kind of cargo fishnet but could only fit one of the end, so I'm trying to print (3d printer FTW!) a better-suited part.
Worst case I will just glue them behind!
 

·
Registered
Joined
·
2,620 Posts
Question out of nowhere, is there an easy way to pop it out without destroying it?
I tried (only once) to put a kind of cargo fishnet but could only fit one of the end, so I'm trying to print (3d printer FTW!) a better-suited part.
Worst case I will just glue them behind!
I've had mine just fall off if they get turned slightly. Appears that you turn it to engage and disengage.
 

·
Registered
Joined
·
5 Posts
I've had mine just fall off if they get turned slightly. Appears that you turn it to engage and disengage.
Hum weird, I tried that and it didn't move at all (it is a new 2019). Thought they were not used in any way before so...
 
1 - 14 of 14 Posts
Top